SCIENTIFIC HIGHLIGHTS

Photoluminescence in Carborane–Stilbene Triads: A Structural, Spectroscopic, and Computational Study
15 November 2016

Dr. Justo Cabrera-González, Prof. Dr. Clara Viñas, Prof. Dr. Matti Haukka, Dr. Santanu Bhattacharyya, Dr. Johannes Gierschner, Dr. Rosario Núñez. DOI: 10.1002/chem.201601177

 A set of triads in which o- and m-carborane clusters are bonded to two stilbene units through Ccluster−CH2 bonds was synthesized, and their structures were confirmed by X-ray diffraction. A study on the influence of the o- and m- isomers on the absorption and photoluminescence properties of the stilbene units in solution revealed no charge-transfer contributions in the lowest excited state, as confirmed by (TD)DFT calculations. The presence of one or two B−I groups in m-carborane derivatives does not affect the emission properties of the stilbenes in solution, probably due to the rather large distance between the iodo substituents and the fluorophore. Nevertheless, a significant redshift of the photoluminescence (PL) emission maximum in the solid state (thin films and powder samples) compared to solution was observed; this can be traced back to PL sensitization, most probably due to more densely packed stilbene moieties. Remarkably, the PL absolute quantum yields of powder samples are significantly higher than those in solution, and this was attributed to the restricted environment and the aforementioned sensitization. Thus, the bonding of the carborane clusters to two stilbene units preserves their PL behavior in solution, but produces significant changes in the solid state. Furthermore, iodinated species can be considered to be promising precursors for theranostic agents in which both imaging and therapeutic functions could possibly be combined.

Hits: 5125
Oxides for new-generation electronics

Photoluminescence in Carborane–Stilbene Triads: A Structural, Spectroscopic, and Computational Study



Also at ICMAB

  • Tuning the tilting of the spiral plane by Mn doping in YBaCuFeO5 multiferroic

    Information
    23 April 2021 84 hit(s) Oxides
    The layered perovskite YBaCuFeO5 (YBCFO) is considered one of the best candidates to high-temperature chiral multiferroics with strong magnetoelectric coupling. In RBaCuFeO5 perovskites (R: rare-earth or Y) A-site cations are fully ordered whereas their magnetic properties strongly depend on the preparation process. They exhibit partial cationic disorder at the B-site that generates a magnetic spiral stabilized through directionally assisted long range coupling between canted locally frustrated spins.
  • New Sensitive and Selective Chemical Sensors for Ni2+ and Cu2+ Ions: Insights into the Sensing Mechanism through DFT Methods

    Information
    09 April 2021 177 hit(s) Oxides
    We report the synthesis and theoretical study of two new colorimetric chemosensors with special selectivity and sensitivity to Ni2+ and Cu2+ ions over other metal cations in the CH3CN/H2O solution. Compounds (E)-4-((2-nitrophenyl)diazenyl)-N,N-bis(pyridin-2-ylmethyl)aniline (A) and (E)-4-((3-nitrophenyl)diazenyl)-N,N-bis(pyridin-2-ylmethyl)aniline (B) exhibited a drastic color change from yellow to colorless, which allows the detection of the mentioned metal cations through different techniques.
  • Silicon nanowires as acetone-adsorptive media for diabetes diagnosis

    Information
    06 April 2021 257 hit(s) Oxides
    Early detection of diabetes, a worldwide health issue, is key for its successful treatment. Acetone is a marker of diabetes, and efficient, non-invasive detection can be achieved with the use of nanotechnology. In this paper we investigate the effect of acetone adsorption on the electronic properties of silicon nanowires (SiNWs) by means of density functional theory.
  • Soft‐Chemistry‐Assisted On‐Chip Integration of Nanostructured α‐Quartz Microelectromechanical System

    Information
    30 March 2021 221 hit(s) Oxides
    The development of advanced piezoelectric α‐quartz microelectromechanical system (MEMS) for sensing and precise frequency control applications requires the nanostructuration and on‐chip integration of this material on silicon material.
  • Critical Effect of Bottom Electrode on Ferroelectricity of Epitaxial Hf0.5Zr0.5O2 Thin Films

    Information
    26 March 2021 258 hit(s) Oxides
    Epitaxial orthorhombic Hf0.5Zr0.5O2 (HZO) films on La0.67Sr0.33MnO3 (LSMO) electrodes show robust ferroelectricity, with high polarization, endurance and retention. However, no similar results have been achieved using other perovskite electrodes so far. Here, LSMO and other perovskite electrodes are compared.

INSTITUT DE CIÈNCIA DE MATERIALS DE BARCELONA, Copyright © 2020 ICMAB-CSIC | Privacy Policy | This email address is being protected from spambots. You need JavaScript enabled to view it.